shenzhen xunlong

Posted on by Jean-Luc Aufranc (CNXSoft) - 40 Comments on How to Use Orange Pi Camera in Linux (with Motion)

How to Use Orange Pi Camera in Linux (with Motion)

Earlier this month, I wrote a Quick Start Guide for Orange Pi Allwinner H3 boards such as Orange Pi PC, and showed how to install and configure Debian on the boards. I’ve also received the $5.90 Orange Pi camera, which when combined an Orange Pi PC, costs around $27 including shipping. So today, I’ve attached the CSI camera to my Orange Pi 2 mini board, and used it with motion to transform for the board into an IP camera. First, you’ll need to insert the camera into CON1 connector with the camera facing the ceiling, and close the black clip to keep it in place. Now connect all cable and power on your board. First, I studied the steps described on that forum thread, and modified Allwinner configuration files, but after one or two hours, I found out some work at been done since May, and it was now much […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 72 Comments on Orange Pi PC Allwinner H3 Board Is Now Available for $15

Orange Pi PC Allwinner H3 Board Is Now Available for $15

Orange Pi 2 is a board powered by Allwinner H3 quad core processor that sells for $25. Shenzhen Xunlong Software has now launched a lower cost version with Orange Pi PC, still based on Allwinner H3 SoC, but getting ridiculously cheap at $15 + shipping ($3.43 in my case). Orange Pi PC specifications: SoC – Allwinner H3 quad core Cortex A7 @ 1.6 GHz (likely 1.2 GHz instead) with an ARM Mali-400MP2 GPU up to 600 MHz System Memory – 1GB DDR3 Storage – micro SD card slot (up to 64GB) Video Output – HDMI with CEC and HDCP support, AV port Audio I/O – HDMI, AV port, on-board microphone Connectivity – 10/100M Ethernet USB – 3x USB 2.0 host ports, 1x micro USB OTG port Camera – CSI Interface Expansions – 40-pin Raspberry Pi compatible header with 28 GPIOs, UART, I2C, SPI, PWM, CAN, I2S, SPDIF, LRADC, ADC, LINE-IN, […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 24 Comments on Allwinner H3 Based Orange Pi 2 Board Price Drops to as Low As $25

Allwinner H3 Based Orange Pi 2 Board Price Drops to as Low As $25

As Raspberry Pi Model B+ price got reduced to $25, some competitors also decided to bring their price down. Shenzhen Xunlong Software, the maker of Orange Pi board, decided to decrease their Orange Pi 2 and Orange Pi 2 Mini boards by $5 to respectively $30 and $25 plus around $2 shipping. Both boards are based on the same PCB, but the mini version lacks WiFi. Let’s refresh our memory with the specs: SoC – Allwinner H3 quad core Cortex A7 @ 1.6 GHz with 256KB L1 cache, 1MB L2 cache, and an ARM Mali-400MP2 GPU up to 600 MHz System Memory – 1GB DDR3 Storage – micro SD card slot (up to 64GB) Video Output – HDMI (CEC and HDCP support), AV port Audio I/O – HDMI, AV port, on-board microphone Connectivity – 10/100M Ethernet, 802.11 b/g/n Wi-Fi (Realtek module, not found on mini version) USB – 4x USB […]

Posted on by Jean-Luc Aufranc (CNXSoft) - 25 Comments on Orange Pi Plus Development Board Gets Upgraded to Allwinner H3 Processor

Orange Pi Plus Development Board Gets Upgraded to Allwinner H3 Processor

Orange Pi boards were recently launched with a form factor similar to the Raspberry Pi Model B+, and featuring Allwinner A20 and A31s processors. Orange Pi Plus was initially fitted with Allwinner A31s processor, but Shenzhen Xunlong Software has now decided to use the latest Allwinner H3 quad core processor instead for this model, adding better CPU performance, and H.265 video decoding up to 4K @ 30 fps, likely at the cost of a slower Mali- 400MP2 GPU against the PowerVR SGX544MP used in Allwinner A31s. New Orange Pi Plus specifications: SoC – Allwinner H3 quad core Cortex A7 @ 1.6 GHz with ARM Mali-400MP2 GPU up to 600 MHz System Memory – 1GB DDR3 Storage – micro SD card slot, SATA interface (via a USB to SATA chip), unpopulated  8GB eMMC on the back of the board (despite picture, see comments section) Video Output – HDMI, AV port Audio […]

UP 7000 x86 SBC