Single Board Computer News - Page 7 of 97 - CNX Software

July 28, 2024August 3, 2024 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Review of Pironman 5 mini PC case for the Raspberry Pi 5 SBC

Pironman 5 review Raspberry Pi 5 tower case

SunFounder has sent me a review sample of the Pironman 5 tower PC case for the Raspberry Pi 5. I had already reviewed the Pironman case for Raspberry Pi 4 last year, so I’ll do something similar this time around with the new Pironman 5 case adding support for NVMe SSD using the PCIe interface from the Pi 5 SBC. The Pironman 5 review will include unboxing and an assembly guide, followed by software installation and features testing (e.g. OLED display, RGB LED control, remote control. soft power off, etc…), before testing the cooling efficiency of the device with some benchmarks. Pironman 5 unboxing The Pironman 5 comes in a package that will be smaller than most people expect. The main features are listed on the side with 5V/5A power input, a 0.96-inch OLED, a tower cooler, M.2 NVMe SSD support, an IR receiver, a CR1220 battery (included), four RGB […]

July 27, 2024July 27, 2024 by Jean-Luc Aufranc (CNXSoft) - 22 Comments

Upgraded Radxa ROCK 5B+ SBC gets LPDDR5 memory, eMMC flash, WiFi 6, two M.2 M-Key sockets, 4G LTE/5G support, and more

The Radxa ROCK 5B+ (“ROCK 5B Plus”) is an upgrade to the Rockchip RK3588-powered ROCK 5B Pico-ITX SBC with the same form factor but various changes including a switch from LPDDR4x to LPDDR5, optional built-in eMMC flash, and an onboard WiFi 6 and Bluetooth 5.2 module instead of one connected through an M.2 Key-E connector. Other changes include replacing the M.2 Key-M PCIe Gen 3 x4 socket with two M.2 Key-M PCIe Gen3 x2 sockets, adding a SIM card slot and M.2 Key-B socket for 4G LTE or 5G cellular connectivity, adding an extra USB-C port for power only (was multiplexed with USB-C Display Port connected in ROCK 5B), and the HDMI input relies on a full-size HDMI port instead of a micro HDMI port. Other small changes can be found in the specifications below with differences highlighted in bold and strikethrough. Radxa ROCK 5B+ specifications: SoC – Rockchip RK3588 […]

July 26, 2024 by Debashis Das - 2 Comments

iBASE IB961 3.5-inch SBC features 13th Gen Intel Core processors, dual 2.5GbE LAN, three M.2 sockets

The iBASE IB961 from FORTEC Integrated (previously known as Distec) is a 3.5-inch Single Board Computer (SBC) built around 13th Gen Intel Core processors. The board can support up to 32GB of DDR5-5200 non-ECC memory via 1x SO-DIMM socket and features dual DisplayPort (1.2), eDP, and LVDS interfaces along with dual 2.5GbE Ethernet for connectivity. Additionally, the SBC also includes 3x M.2 slots (M-Key, E-Key, B-Key) for expanded storage and 5G cellular communication. These features make the device useful for applications like automation, edge computing, transportation, digital signage, and kiosks/ATMs. iBASE is well known for its SBCs and mini PCs and previously we have written about their products including the IBASE ISR500 fanless Edge AI computer, the IBASE 3.5-inch SBC with AMD Ryzen Embedded V2000 processor, the IBASE IBR215 Pico-ITX SBC. Additionally, we have written about similar SBCs and Mini PCs with 13th-gen Raptor Lake SoC including the GEEKOM GT13 […]

July 23, 2024July 23, 2024 by Jean-Luc Aufranc (CNXSoft) - 6 Comments

tinySniffer WiFi-connected USB sniffer is based on NanoPi NEO Air SBC

TinySniffer is a USB sniffer based on the Allwinner H3-powered NanoPi Neo Air SBC, designed to capture USB 1.x and 2.0 packets remotely, and whose captured data is compatible with the popular Wireshark packet analyzer tool. Wireshark can already be used to capture USB packets on its own and I reverse-engineered a USB capture video solution that way in the past, but this method has some limitations, for instance, it does not capture some low-level USB packets, in which case a hardware USB sniffer like Total Phase Beagle USB, the PhyWhisperer USB, or the tinySniffer is required. The micro USB OTG port of the NanoPi NEO Air SBC is connected to the host computer and the company added a USB 2.0 Type-A port connected to the USB interface on the GPIO header to connect a device under test such as a USB keyboard, a USB Ethernet dongle, a USB printer, […]

July 19, 2024July 20, 2024 by Jean-Luc Aufranc (CNXSoft) - No Comments

Texas Instruments AM6232/AM6254-powered SBC and industrial IoT gateway offered with a 20-year lifespan

AAEON PICO-AM62 TI AM62x Sitara PIco ITX SBC

AAEON’s PICO-AM62 and SRG-AM62 are respectively a single board computer (SBC) and an industrial IoT gateway powered by Texas Instruments AM6232 or AM6254 Sitara Arm Cortex-A53/M4 SoC, designed to operate within the -40°C to 85°C temperature range, and offered with a 20-year lifespan. The SRG-AM62 gateway simply houses the PICO-AM62 pico-ITX SBC within a metal case so both offer dual gigabit Ethernet, HDMI 1.4 port, and two USB 2.0 as well as communication interfaces such as RS-232/422/485 and CAN Bus. Designed to be operated in industrial settings, the systems support a wide 9V to 36V input voltage range. PICO-AM62 SBC and SRG-AM62 gateway specifications: SoC – Texas Instruments AM623x either AM6232 Sitara with dual-core Arm Cortex-A53 processor @ up to 1.4 GHz, Cortex-M4F real-time core @ 400 MHz, no 3D GPU AM6254 Sitara with quad-core Arm Cortex-A53 processor @ up to 1.4 GHz, Cortex-M4F real-time core @ 400 MHz, Imagination […]

July 19, 2024July 20, 2024 by Jean-Luc Aufranc (CNXSoft) - 36 Comments

Radxa X4 low-cost, credit card-sized Intel N100 SBC goes for $60 and up

Radxa X4 is a credit card-sized Intel Processor N100 single board computer (SBC) that costs almost the same as a Raspberry Pi 5 with the 4GB RAM model going for about $60 and the 8GB RAM variant around $80. The x86 SBC offers many of the same features as the Raspberry Pi 5 including dual micro HDMI output, four USB 3.2/2.0 ports, Ethernet and WiFi networking, and the 40-pin GPIO header handled through a Raspberry Pi RP2040 microcontroller. Networking is better with 2.5GbE and WiFi 6, M.2 SSD support is built-in and four to eight times faster compared to PCIe HAT for the Pi 5, and the USB 3.2 ports are capable of 10 Gbps speed. So let’s little not too like, and the main downside is the lack of MIPI CSI and DSI connectors for projects requiring those camera and display interfaces. Radxa X4 specifications: SoC – Intel Processor […]

July 18, 2024July 17, 2024 by Jean-Luc Aufranc (CNXSoft) - 11 Comments

Panthor open-source driver achieves OpenGL ES 3.1 conformance with Arm Mali-G610 GPU (RK3588 SoC)

Panthor OpenGL ES 3.1 conformance Mali G610

Collabora has just announced that the Panthor open-source GPU kernel driver for third-generation Arm Valhall GPUs (Arm Mali-G310, Mali-G510, Mali-G610, and Mali-G710) has now achieved OpenGL ES 3.1 conformance with the Arm Mali-G610 GPU found in the Rockchip RK3588 SoC. Just a few days ago, Linux 6.10 was released with “support for Mali CSF-based GPUs found on recent Arm SoCs from Rockchip or Mediatek”, as expected from the earlier article entitled “Panthor open-source driver for Arm Mali-G310, Mali-G510, Mali-G610, and Mali-G710 GPUs to be part of Linux 6.10” published last March. But this did not say anything about the level of support for the Valhall GPU since it’s common for new hardware to be added with minimal support, and OpenGL ES 3.1 compliance means it’s ready for business… Collabora’s announcement explains this was tested on a Radxa Rock 5B single board computer: The conformance tests ran on a Rock5b board […]

July 15, 2024July 16, 2024 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

Linux 6.10 Release – Notable changes, Arm, RISC-V, and MIPS architectures

Linux Torvalds has announced the release of Linux 6.10 on LKML: So the final week was perhaps not quote as quiet as the preceding ones, which I don’t love – but it also wasn’t noisy enough to warrant an extra rc. And much of the noise this last week was bcachefs again (with netfs a close second), so it was all pretty compartmentalized. In fact, about a third of the patch for the last week was filesystem-related (there were also some btrfs latency fixes and other noise), which is unusual, but none of it looks particularly scary. Another third was drivers, and the rest is “random”. Anyway, this obviously means that the merge window for 6.11 opens up tomorrow. Let’s see how that goes, with much of Europe probably making ready for summer vacation. And the shortlog below is – as always – just the last week, not some kind […]