openwrt News - Page 11 of 36 - CNX Software

October 19, 2022 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

MaxLinear unveils MxL31712 & MxL31708 Wi-Fi 7 chips for gateways, routers and access points

MaxLinear has unveiled its first Wi-Fi 7 SoCs with the MxL31712 and the MxL31708 single-chip solutions targeting service provider gateways, Wi-Fi routers, and access points, and delivering more than 70% higher tri-band throughput compared to Wi-Fi 6. The MxL31712 aims at the premium 4×4 tri-band market with a throughput of up to 18.6 Gbps and up to 12 spatial streams, while the MxL31708 will be integrated into mid- to high-range 4×4 dual-band access points and gateways with a throughput of up to 17 Gbps, and up to 8 spatial streams. MaxLinear MxL31712 and MxL31708 share the following features: Single-chip WFA Wi-Fi 7 R1 certifiable Based on IEEE 802.11be (aka WiFi 7 or Extremely High Throughput “EHT”) backward compliant to IEEE 802.11a/b/g/n/ac/ax WiFi 6 Wi-Fi 7 features: Bandwidth up to 320MHz 4096 QAM modulation Multi-Link Operation (MLO) Multi Resource Unit (MRU) Dedicated antenna for Zero Wait DFS (ZWDFS) Enhanced Network […]

October 6, 2022 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Allwinner V851S/V851SE low-cost camera SoC embeds 64MB DDR2, a 0.5 TOPS NPU

Allwinner V851S/V851SE is a single-core Arm Cortex-A7 SoC with a RISC-V core, an H.265/H.264 video encoder, and a 0.5 TOPS NPU designed for Smart IP cameras with support for features such as human detection and crossing alarms. Both processors ship with 64MB DDR2 memory, and feature USB, Ethernet, and SDIO interfaces, but the V851S is designed for systems with a display, while the V851SE targets traditional headless IP cameras. Both processors are pretty similar, but here are the key differences between Allwinner V851S: Networking – 10/100 Mbps Ethernet port with RMII interface GPIO – 6x ports (PA, PC, PD, PE, PF, PH) Display LCD Parallel RGB, Serial RGB, i8080, BT656 2-lane MIPI DSI SPI – 4x SPI and Allwinner V851SE: Networking – SIP 100 Mbps EPHY GPIO – 5x ports (PA, PC, PE, PF, PH) Display – Not supported SPI – 3x SPI That means the Allwinner V851S requires an […]

September 30, 2022 by Jean-Luc Aufranc (CNXSoft) - 5 Comments

Nuvoton NuMicro MA35D1 Arm Cortex-A35/M4 microprocessor to power Linux edge IIoT gateways

Novoton NuMicro MA35D1 microprocessor features two Arm Cortex-A35 cores, one Arm Cortex-M4 real-time core, and two Ethernet interfaces for Linux-based edge IIoT gateway. The SoC also is offered in variants supporting external DDR memory or integrated up to 512MB RAM, 154 or 208 GPIOs, and an optional “Enhanced ADC”. The MA35D1 also comes with a TFT interface for up to 1920×1080 displays, several hardware security features, and the company says the microprocessor facilitates Tiny AI/ML for edge computing despite not integrating an AI accelerator. Nuvoton NuMicro MA35D1 key features and specifications: CPU sub-system 2x Cortex-A35 cores running at up to 800 MHz Cortex-M4 real-time core at up to 180 MHz Memory sub-system On-chip 384 KB SRAM (Cortex-A35 256 KB + Cortex-M4 128 KB) Multi-Chip Package (MCP) DDR up to 512MB External DDR interface for MA35D16A087C SKU Storage Quad SPI NAND Flash Controller Secure Digital Host Controller (SDHC) Display and Video […]

September 9, 2022 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

MaxLinear AnyWAN URX850, URX851, and MxL25641 Intel Atom SoCs target broadband routers and gateways

MaxLinear AnyWAN Atom SoC broadband routers

MaxLinear has just announced the availability of the first three AnyWAN broadband SoCs featuring Intel Atom cores with the MxL25641, URX850, and URX851 processors designed for 5Gbps and 10 Gbps broadband routers and gateways, usually referred to as CPEs (customer premise equipment). When I first read the news of MaxLinear releasing Intel Atom SoCs, I could not quite compute how it was possible, as I can’t remember any third-party releasing Intel processors and I thought it might be a system-in-package instead. But MaxLinear keeps calling those Intel Atom SoCs, and the reason is that the company acquired Intel’s Home Gateway Platform Division in 2020. MaxLinear AnyWAN x86 SoCs key features and specifications: AnyWAN URX850/URX851 (for 10Gbps systems) CPU – 4x Intel Atom CPU cores @ 2 GHz Memory – Up to 16GB LPDDR4 or DDR4 Storage – eMMC 5.1 flash Networking 4x 2.5GE PHYs XFI WAN Packet processor for full […]

September 7, 2022 by Jean-Luc Aufranc (CNXSoft) - 9 Comments

OpenWrt 22.03 released with Firewall4, now supports over 1,580 embedded devices

OpenWrt 22.03 open-source Linux operating system for routers and entry-level embedded devices has just been released with over 3800 commits since the release of OpenWrt 21.02 nearly exactly one year ago. The new version features Firewall4 based on nftables, switching from the earlier iptables-based Firewall3, and adds support for over 180 new devices for a total of more than 1,580 embedded devices, including 15 devices capable of WiFi 6 connectivity using the MediaTek MT7915 wifi chip. OpenWrt developers explain that Firewall4 keeps the same the UCI firewall configuration syntax and should work as a drop-in replacement with most common setups, just generating nftables rules instead of iptables ones. You’ll find more details about OpenWrt firewall configuration in the documentation. OpenWrt 21.02 added initial support for the Distributed Switch Architecture (DSA), the Linux standard for configurable Ethernet switches, and OpenWrt 22.03 migrated more targets from swconfig to DSA namely all bcm53xx […]

September 6, 2022 by Jean-Luc Aufranc (CNXSoft) - 15 Comments

Topton N1 dual-bay NAS features AMD Athlon 3050e CPU, four Ethernet ports

Powered by an AMD Athlon Silver 3050e dual-core processor, Topton N1 (aka TP-N1) NAS comes with two SATA bays for 2.5-inch or 3.5-inch drives, as well as four gigabit Ethernet ports. The system can support up to 32GB RAM, relies on M.2 SSD storage for the OS, and can provide up to 40TB of data storage through the two SATA bays. It is also equipped with an HDMI output port, several USB 3.x/2.0 ports, as well as a 3.5mm audio jack. Topton N1 specifications: SoC – AMD Athlon Silver 3050e dual-core/quad-thread processor @ 1.4 / 2.8 GHz (Turbo) with Radeon Vega 3 graphics @ 1 GHz; TDP: 6W System Memory – Up to 32GB DDR4-2400 RAM via two SO-DIMM slots Storage M.2 2280 socket for a (PCIe 3.0) NVMe SSD 2x SATA III bay for 2.5-inch and 3.5-inch driver for a maximum of 40TB data storage (based on currently available […]

September 5, 2022September 5, 2022 by Jean-Luc Aufranc (CNXSoft) - 16 Comments

Banana Pi BPI-R3 WiFi 6 router board features MediaTek Filogic 830/MT7986 SoC

I first noticed the MediaTek MT7986 WiFi router processor in Linux 5.17 changelog. MT7986 is the codename for MediaTek Filogic 830 quad-core Cortex-A53 processor designed for Wi-Fi 6/6E routers with up to 6 Gbps bandwidth, and two 2.5Gbps Ethernet interfaces. Banana Pi BPI-R3 is a router board based on Filogic 830/MT7986A that offers an upgrade to the company’s Banana Pi BPI-R2 board powered by a MediaTek MT7623A quad-core Cortex-A7 processor or even the Banana Pi BPI-R64 board based on a MediaTek MT7622 dual-core Arm Cortex-A53 SoC. Banana Pi BPI-R3 specifications: SoC – MediaTek MT7986A (Filogic 830) quad-core Arm Cortex A53 processor with hardware acceleration engines for Wi-Fi offloading and networking System Memory – 2GB DDR RAM Storage – 8GB eMMC flash, MicroSD card socket, support for M.2 NVMe SSD Networking 2x 2.5GbE SFP cages, 5x Gigabit Ethernet ports (1x WAN + 4x LAN) via MT7531AE 7-port switch WiFi 6 4×4 […]

August 30, 2022October 21, 2022 by Jean-Luc Aufranc (CNXSoft) - 14 Comments

MangoPi MQ Quad SBC – Allwinner H616 meets Raspberry Pi Zero W form factor

MangoPi MQ Quad is an Allwinner H616 quad-core Arm Cortex-A53 SBC following Raspberry Pi Zero W form factor, and the company’s earlier MangoPi MQ Pro RISC-V SBC featuring the Allwinner D1 processor. The MangoPi MQ Quad also comes with 1GB RAM, a mini HDMI output, two USB Type-C ports, WiFI 4 and Bluetooth connectivity, a microSD card, as well a 40-pin Raspberry Pi-compatible GPIO header and an FPC connector with USB, Ethernet, and more GPIOs for expansion. MangoPi MQ Quad specifications: SoC – Allwinner H616 quad-core Cortex-A53 @ 1.5GHz with Mali-G31 MP2 GPU with OpenGL 3.2, Vulkan 1.1, OpenCL 2.0 API support System Memory – 1GB DDR3L Storage – MicroSD card slot, a footprint for SPI flash (on the bottom of the board) Video Output – Mini HDMI 2.0 port up to 4Kp60 Connectivity – 802.11 b/g/n WiFi 4 and Bluetooth 4.2 via RTL8723DS; ceramic and u.FL antennas included USB […]