lte News - Page 17 of 20 - CNX Software

December 8, 2016 by Jean-Luc Aufranc (CNXSoft) - 12 Comments

SDMC DV8219-LTE Android TV Box Comes with a Built-in 4G LTE Modem

Most users connect their TV boxes to the Internet through WiFi or Ethernet, but in some specific use case, such as digital signage in mass transport or in remote locations, it might be useful to get access to cellular networks. We’ve seen a few Android TV boxes with a built-in 3G modem in the past including CS918S and MBX-3G, but the former is based on the rather old Allwinner A31s processor, and the latter did not raise enough found on Indiegogo. But there’s nothing new, as SDMC DV8219-LTE is a more recent TV box powered by Amlogic S905X processor and running Android 6.0, equipped with a 4G LTE modem. SDMC DV8219-LTE TV box specifications: SoC – Amlogic S905X quad core Cortex A53 processor @ up to 1.5 GHz with a Mali-450MP GPU System Memory – 1GB DDR3 SDRAM (2GB as option) Storage – 8GB eMMC flash (4 to 64GB as […]

November 24, 2016 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

39 Euros FiPy Board Supports Sigfox, LoRa, LTE Cat M1/NB1, Bluetooth 4.2, and WiFi (Crowdfunding)

Long range LPWAN solutions have just started to hit the market, and there are so many standards such as Sigfox and LoRa that it’s difficult to know who will eventually be the winner, or if different standards will co-exist over the long term, and in a general sense it might not be so easy to decide which one is best suited to your project without experimenting first. Pycom has a solution to this problem, as they’ve made a board similar to LoPy with WiFi, Bluetooth, and LoRa, but instead included 5 long and short range IoT protocols: Sigfox, LoRa, LTE Cat M1 & Cat NB1, Bluetooth, and WiFi. Pycom FiPy board specifications: SoC – Espressif ESP32 dual core Tensilica L108 processors @ up to 160 MHz with BT 4.2 and WiFi System Memory – 4MB RAM Storage – 8MB flash memory Connectivity WiFi 802.11 b/g/n @ 16 Mbps up to […]

October 20, 2016October 20, 2016 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

HiSilicon Kirin 960 Octa Core Application Processor Features ARM Cortex A73 & A53 Cores, Mali G71 MP8 GPU

Following on Kirin 950 processor found in Huawei Mate 8, P9, P9 Max & Honor 8 smartphones, Hisilicon has now unveiled Kirin 960 octa-core processor with four ARM Cortex A73 cores, four Cortex A53 low power cores, a Mali G71 MP8 GPU, and an LTE Cat.12 modem. The table below from Anandtech compares features and specifications of Kirin 950 against the new Kirin 960 processor. SoC Kirin 950 Kirin 960 CPU 4x Cortex A72 (2.3 GHz) 4x Cortex A53 (1.8 GHz) 4x Cortex A73 (2.4 GHz) 4x Cortex A53 (1.8 GHz) Memory Controller LPDDR3-933 or LPDDR4-1333 (hybrid controller) LPDDR4-1800 GPU ARM Mali-T880MP4 @ 900 MHz ARM Mali-G71MP8 @ 900 MHz Interconnect ARM CCI-400 ARM CCI-550 Encode/ Decode 1080p H.264 Decode & Encode2160p30 HEVC Decode 2160p30 HEVC & H.264 Decode & Encode2160p60 HEVC Decode Camera/ISP Dual 14bit ISP 940MP/s Improved Dual 14bit ISP Sensor Hub i5 i6 Storage eMMC 5.0 UFS 2.1 Integrated Modem […]

October 18, 2016 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

Qualcomm Introduces Three New LTE Cat. 7 SoCs with QC 3.0 and Dual Camera Support: Snapdragon 427, 626, and 653

Qualcomm has announced three new Snapdragon 400 & 600 SoCs for entry-level and mid-range LTE smartphones that share Quick Charge 3.0 and dual camera support, as well as an a Snapdragon X9 LTE CAT 7 modem capable of 300Mbps downlink, 150Mbps uplink. Snapdragon 427 Snapdargon 427 quad core Cortex A53 processor is a pin-to-pin compatible update to Snapdragon 425 processor with a faster Cat 7 modem. The Snapdragon 427 is also the first in the Snapdragon 400 family to offer TruSignal antenna tuning for 802.11ac WiFi, includes a 16MP dual ISP, and supports displays up to 1280×800 resolution. You’ll find more details on the product page. Snapdragon 626 Snapdragon 626 octo-core ARM Cortex A53 processor up to 2.2 GHz features a “PC-class” Adreno Adreno 506 GPU, a 24MP dual ISP, also supports TruSignal, 4K @ 30 fps video recording, and displays up to 1920×1200 resolution. It’s a pin-to-pin compatible upgrade […]

October 18, 2016October 18, 2016 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

NETGEAR Gigabit Class LTE Mobile Router MR1100 is Powered by Qualcomm Snapdragon X16 LTE Modem

Qualcomm, NETGEAR, Telstra and Ericsson have jointly announced the very first commercial Gigabit LTE modem router with NETGEAR Mobile Router MR1100 based on Qualcomm Snapdragon X16 LTE modem. The NETGEAR Mobile Router MR1100 leverages 3x carrier aggregation, 4×4 MIMO, and 256-QAM, to achieve download speeds up to a peak of 979 Mbps. The device also integrates Qualcomm 802.11ac solution with 2×2 MIMO and dual-band support for overall Wi-Fi throughput of up to 1Gbps. Qualcomm Technologies has recently conducted a simulation of a Gigabit Class LTE network, using a mix of LTE devices (LTE Category 4 to 16), and found average throughput to be between 112 Mbps and 307 Mbps for Cat.16 devices depending on traffic type, but speeds up to 533 Mbps should be possible for 90th percentile users. Beside shortening download speeds, this kind of performance will enable new applications such as 4K 360 degrees VR videos up to […]

September 8, 2016February 25, 2018 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

u-Blox Unveils SARA-R4 LTE Cat M1 and SARA-N2 NB-IoT Modules for Professional IoT Applications

While I’ve mostly read about SigFox and LoraWan solutions for long range, low power, and low bitrate communications for the Internet of Things so far, there are many active of planned LPWAN standards for IoT applications, and 3GPP Release 13 standard stipulates two LTE LPWAN standards, namely LTE Cat M1 (eMTC) and LTE Cat NB1 (NB-IoT), with the former supporting 1 Mbps downlink and uplink peak data rates, and the latter 250 Kbps downlink, and 250 Kbps (multi-tone) or 20 Kbps (single tone) uplink data rates. U-Blox has released modules for both standard with SARA-R4 LTE Cat M1 and SATA-N2 NB-IoT modules. SARA-N2 Cat NB1 cellular module specifications: LPWAN Connectivity – 3GPP Release 13 NB1; NB-IoT bands: 5, 8, 20; downlink: 227 Kbps, uplink: 21 Kbps Positioning – GNSS via Modem Interfaces – 1x UART, 1x SPI, 2x GPIO, 1x DDC(I2C) for GNSS Features – Antenna supervisor, embedded IPv4 & […]

July 7, 2016July 7, 2016 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

OpenCellular is Facebook’s (soon to be) Open Source Wireless Access Platform

A few months after Canonical and Lime Micro LimeSDR open source software defined radio aiming to be used as a development platform, but also as the base for low cost cellular or other wireless base stations, Facebook has announced their own open source wireless access platform with OpenCellular project whose goal is to lower the cost of Internet connectivity in remote areas where the infrastructure does not exist. This is how Marc Zuckerberg summarizes the project: We designed OpenCellular as an open system so anyone — from telecom operators to researchers to entrepreneurs — can build and operate wireless networks in remote places. It’s about the size of a shoe box and can support up to 1,500 people from as far as 10 kilometers away. Along with our solar-powered aircraft Aquila and high-bandwidth laser beams, OpenCellular is the next step on our journey to provide better, more affordable connectivity to […]

July 5, 2016 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Allwinner and Qualcomm Partner on Android and Windows 10 LTE Tablets

Allwinner, a leading tablet SoC vendor, and Qualcomm have decided to collaborate, and introduced three new LTE tablet reference designs based on Qualcomm Snapdragon 425, 430, and 435 available to Chinese OEMs, on top of Snapdragon 210, 212 and 410 designs released last year. The full technical technical details about the reference designs are only available to OEMS who signed an NDA, but the key specifications are as follows: SoC – Qualcomm Snapdragon 420, 430, 435 application processors System Memory – 2G DRAM Storage – 32GB internal memory Connectivity – CAT 6 LTE band The tablet will run Android, but Windows 10 is also being worked on. The agreement only covers tablets, so Allwinner will not be involved in LTE smartphones. Since both Allwinner and Qualcomm are silicon vendors, and competitors, you may wonder why they’ve partnered. Allwinner only provides WiFi and Bluetooth tablets with their own processors, so partnering with Qualcomm allows then to […]