Lantronix has recently launched XPort(R) Pro Lx6, a secure embedded device server supporting IPv6, that barely larger than an RJ45 connector. The device runs Linux or the company’s Evolution OS, and is destined to be used in wired industrial IoT / M2M applications. Lantronix XPort Pro Lx6 Specifications: Processor – Freescale ColdFire MCF5208 up to 166.67 MHz (TBC) 32-bit processor System memory – 16MB SDRAM Storage – 16MB Flash Serial Interface – Software selectable data rates from 300 to 921kbps Programmable IO – 3 PIO pins (software selectable) Network Interface – 10Base-T and 100Base-TX Link with support for IPv4 and IPv6, and the following protocols: TCP/IP, UDP/IP, ARP, ICMP, SNMPv2, TFTP, FTP, Telnet, DHCP, BOOTP, HTTP, SMTP, PPP, AutoIP, RSS, and SYSLOG Security – TCP/AES and UDP/AES Temperature Range – Operating and storage: -40° to +85° C Relative Humidity – 0% to 90% non-condensing Regulatory Approvals – FCC Part 15, Subpart […]
Lantronix Unveils xPico Wi-Fi Module For the Internet of Things
With Texas Instruments SimpleLink Wi-Fi CC3000 and Qualcomm Atheros AR4100P embedded Wi-Fi processors that fully handle Wi-Fi internally, and transfer data to an MCU with an SPI interface, and solutions such as Electric Imp, there are already ways to add Wi-Fi at relatively low cost to appliances. There’s now another solution available on the market with Lantronix xPico Wi-Fi Module. Listed features and specification of xPico Wi-Fi: SoC – ARM Cortex M3 class processor with 1MB on-chip Flash and 128 KB SRAM Storage – SPI Flash storage Wireless LAN Interface IEEE 802.11 b/g and IEEE 802.11n (single stream) WLAN interface (2.4 GHz only) IEEE 802.11 d/h/i/j/k/w/r WPS 2.0 support u.FL connector for external antenna Serial Interface Two Serial CMOS Ports (3.3V, 5V tolerant) 300 to 921.6 Kbps Flow control XON/XOFF, RTS/CTS (SPort 1 only) Lantronix tunneling application (SPort 1 only) Host Interface – Dual Serial Port, SPI, USB 2.0 (device), […]