io-link

Posted on by Tomisin Olujinmi - 2 Comments on STMicro releases IO-Link actuator board for industrial monitoring and home appliances

STMicro releases IO-Link actuator board for industrial monitoring and home appliances

STMicro EVLIOL4LSV1 IO-Link actuator board

STMicro has announced the EVLIOL4LSV1 IO-Link actuator board, an STM32G071CB Cortex-M0+ MCU-based reference design for commercial manufacturers with a built-in protocol stack and application software. Aimed at industrial beacons and home-appliance alarms, the EVLIOL4LSV1 combines the L6364Q dual-channel IO-Link transceiver (communications) and IPS4260L intelligent low-side power switch (for driving industrial loads). The EVLIOL4LSV1 IO-Link actuator board is powered by an STM32G071CB Arm-Cortex-M0+ microcontroller that hosts the proprietary stack and application software and communicates with the transceiver and low-side power switch. The evaluation board can be used to test the IPS4260 and L6364Q ICs. It features a 4-pin M12 connector for an IO-LINK master and a 5-pin SWD connector for programming. It can also directly interface with signaling systems, ranging from smart tower lights in factory automation to funnel alarms for quantity monitoring. The onboard transceiver is protected against electromagnetic interference and supports COM2 and COM3 speeds. It offers multiple modes […]

Posted on by Debashis Das - No Comments on Renesas CCE4511 IO-Link master IC and ZSSC3286 IO-Link sensor signal conditioner IC are designed for industrial sensors and actuators

Renesas CCE4511 IO-Link master IC and ZSSC3286 IO-Link sensor signal conditioner IC are designed for industrial sensors and actuators

Renesas CCE4511 and ZSSC3286 IO Link ICs

Renesas has recently introduced the CCE4511 four-channel IO-Link master IC and the ZSSC3286 IO-Link-ready dual-channel sensor signal conditioner IC along with their development boards designed for harsh industrial environments. The CCE4511 master IC supports four channels with 500mA driving current, overvoltage detection, and overcurrent protection, Additionally, it has an integrated IO-Link Frame Handler that reduces microcontroller load. The ZSSC3286on is the first sensor signal conditioner with an integrated IO-Link compliant stack, meaning you don’t need a separate microcontroller for signal handling. Additionally, it features 24-bit ADCs and advanced diagnostic functions for advanced tasks. Both products are optimized for industrial automation, offering energy efficiency, smaller PCB sizes, and robust system diagnostics. CCE4511 IO-Link master and ZSSC3286 sensor signal conditioner IC Specifications CCE4511 IO-Link master Main Chip – CCE4511 4-Channel IO-Link Master PHY with integrated Frame Handler Number of Channels – 4 IO-Link master channels Frame Handler – Hardware frame handler for […]

UP 7000 x86 SBC