som News - Page 68 of 78 - CNX Software

March 12, 2015 by Jean-Luc Aufranc (CNXSoft) - No Comments

Compulab Announces CM-T43 CoM and SBC-T43 Board Powered by TI Sitara AM437x Processors

Compulab has just introduced CM-T43 computer-on-module (CoM) powered by Texas Instruments Sitara AM437x ARM Cortex A9 processor and built-in wired and wireless connectivity, and targeting networking, industrial communications and IoT applications. The company has also announced the corresponding SBC-T43 single board computer featuring the module plus a baseboard. Compulab CM-T43 Module CM-T43 CoM specifications: SoC – Texas Instruments Cortex-A9 Sitara AM4376 / AM4379 SoC up to 1GHz with PowerVR SGX530 GPU (AM4379 only) System Memory – Up to 1GB DDR3 Storage – 4GB to 32GB on-board eMMC, 128MB to 512MB on-board SLC NAND Connectivity – 2x Gigabit Ethernet PHY, and Marvell 88W8897 chipset for dual-band, dual-antenna 2×2 MIMO 802.11ac/a/b/g/n WiFi, Bluetooth 4.0 Low Energy, and NFC (ISO 14443A/B, ISO 18092 and ISO 15693) Audio codec – Wolson Audio codec with stereo line-out, line-in, mic via edge connector 204-pin SO-DIMM edge connector with access to: USB2.0 high-speed dual-role (host / device) port, […]

March 11, 2015 by Jean-Luc Aufranc (CNXSoft) - No Comments

Emcraft Systems STM32F7 ARM Cortex M7 SoM and Development Kit Run uClinux

STMicro announced their STM32F7 MCU family the same as ARM announced their latest ARM Cortex M7 core for high-end micro-controllers last September. Emcraft Systems have now launched a STM32F7 system-on-module with 32MB SDRAM and 16MB NOR flash, and ported uClinux to the platform. The company has also launched a STM32F7 starter kit for evaluation and development. Both target industrial automation, system and power management, wireless networking / sensors and other embedded applications. STM32F7-SOM-1A Module STM32F7 system-on-module specifications: MCU – STMicro STM32F746 Cortex M7 MCU up to 200 MHz with 320KB RAM, 1MB flash in TFBGA-216 package System Memory – 32MB SDRAM Storage – 16MB NOR flash Connectivity – 802.3 Ethernet PHY SoM connectors – 2x 80-pin (0.4mm pitch) Debugging – ARM SWJ-DP combined JTAG and serial wire debug port Misc – Watchdog, RTC, USB and other I/Os via SoM connectors Power – 3.3V DC; Low-power mode with short startup times; […]

February 22, 2015 by Jean-Luc Aufranc (CNXSoft) - No Comments

DENX Computer Systems Introduces Atmel SAMA5D44 and Freescale i.MX6 System-on-Modules

Embedded World 2015 exhibition and conference will take place in Nuremberg, Germany on February 24-26, 2015, and we should expect interesting news related to MCU, industrial processors, and related development kits and boards next week. DENX Computer Systems has already unveiled two new SoM families with MA5D4 based on Atmel SAMA5D44 Cortex A5 processor, and M6R based on Freescale i.MX 6 Cortex A9 processors. DENX MA5D4 System-on-Module MA5D4 SoM specifications: Processor – Atmel SAMA5D44 Cortex A5 @ 528MHz with 720p hardware video decoder supporting H264/263, VP8, JPEG. System Memory – 128 – 512MB DDR2 RAM Storage – 4 – 32GB eMMC Flash (or optionally 256MB NAND Flash); 4 MB MByte SPI NOR-Flash; I/Os via 230-pin MXM2 edge connector Video Out / Display Support – HDMI. TFT controller, overlay support for image composition, resitive Touchscreen controller Camera – CMOS image sensor interface external bus A/D 25/16 bit 2x 10/100MBit Ethernet, IEEE1588 […]

February 19, 2015 by Jean-Luc Aufranc (CNXSoft) - No Comments

Olimex Announces Availability of TI AM3352 and Rockchip RK3188 SoM and Evaluation Boards

Olimex showcased prototypes for both Texas Instruments Sitara AM3352 and Rockchip RK3188 system-on-modules and evaluation boards in May 2014. However, development and production took a bit longer than expected, and the company has just announced availability of the platforms now. Rockchip RK3188 CPU Modules and Kit RK3188-SOM-EVB kit specifications: RK3188-SOM-4GB System-on-Module with the following key features: SoC – Rockchip RK3188 quad core Cortex A9 processor @ 1.6GHz with Mali-400MP4 GPU System Memory – 1GB DDR3 Storage – 4GB Flash + micro SD slot Debugging – 4-pin UART connector Misc – Reset and Recovery buttons, 3x status LEDs Dimensions – 55.88 x 81.28 mm Video Output – HDMI output + LCD output Connectivity – 10/100Mbps Ethernet USB – 4x USB Hosts, 1x micro USB OTG Expansion Connectors LCD connector for LCD-OLinuXino-XX LCDs 2x UEXT connectors 2x 40 pin GPIO connectors Misc – RTC with backup battery Power Supply – 6-16 V via […]

January 30, 2015 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

Variscite Introduces TI Sitara AM437x SoM with Bluetooth and Wi-Fi

News about Texas Instruments Sitara AM437x processors first surfaced in 2012, before being officially announced last summer. Beside TI’s own development kits, I had not seen any hardware based on the company’s Cortex A9 industrial processor, but Variscite has now unveiled their VAR-SOM-AM43 systems-on-module (SoM) powered by AM4376 , AM4378, or AM4379 SoCs. VAR-SOM-AM43 specifications: SoC – Texas Instruments AM437x single core ARM Cortex A9 processor @ 1.0GHz: AM4376 – No GPU, 4x PRU @ 200 MHz AM4378 – PowerVR SGX530 GPU, 4x PRU @ 200 MHz AM4379 – PowerVR SGX530 GPU, 4x PRU @ 200 MHz, and EtherCAT slave support System Memory – 256MB to 1GB DDR3 Storage – 0 to 512MB SLC NAND flash, and 4GB to 32GB eMMC flash b module. 3x SD/MMC via edge connector Display Interfaces – 24-bit RGB interface up to 1400×1050 resolution; 4/5-wire resistive touch support Connectivity – 10/100/1000 Mbps Ethernet PHY + […]

January 5, 2015January 5, 2015 by Jean-Luc Aufranc (CNXSoft) - No Comments

LinkIt A-Core Packs Mediatek MT2502A SoC into a Tiny Module for Wearables

LinkIt ONE is a development board based on Meditak MT2502A SoC for wearables, and developed by SeeedStudio. With GPS, Wi-Fi, and GSM/GPRS connectivity, and a LiPo battery, it’s great to experiment IoT or wearable applications, but if you plan to launch an actual product, it could be nice to have a module, and built a baseboard around it. That’s exactly what SeeedStudio is working with LinkIt A-Core module. LinkIT A-Core module specifications: SoC – Mediatek MT2502AV ARM7 SoC @ 260 MHz with 32MB PSRAM and 32MB Flash on-chip. External Storage – 16M external Flash (MX25U12835F) Cellular Connectivity – GSM/GPRS quad-band 850/900/1800/1900MHz with RF7198 RF transmitter. Connectivity – Bluetooth 2.0 / 2.0 EDR / 4.0, GPS compatible GPS/GNSS (requires external GPS module) Expansion – 48 general purpose digital I/O Power supply: DC 3V~4.2V Power Consumption – > 3mA Dimensions – 19x23x2 mm The module is still in development, and the company welcomes […]

December 4, 2014May 1, 2016 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

e-con Systems Unveils eSOMiMX6 SoM based on μQ7 Form Factor, and Ankaa Development Kit

QSeven is one of the many standards for system-on-modules, and it defines both Qseven (Q7) 70x70mm modules, and smaller μQSeven (μQ7) 70x40mm modules. While there are quite a few SoMs following the larger form factor, few modules are based on micro Q7, and e-con Systems eSOMiMX6 has just launched one of these tiny modules with eSOMiMX6 system-on-module powered by Freescale i.MX6 processors, as well the corresponding Ankaa development kit comprised of the SoM and a baseboard. eSOMiMX6 module specifications: SoC – Freescale i.MX6 single, dual or quad Cortex A9 processor @ 800MHz to 1.2 GHz with Vivante GPUs System Memory – 256MB/512MB (Solo only), 1GB (default), or 2GB (dual/quad only) LVDDR3 RAM Storage – 4GB (default) to 64GB eMMC flash, 2MB SPI NOR flash, and SD/MMC + SATA II interfaces via MXM connector Display / Video Output: HDMI up to 1920 x 1080 Dual channel 24-bit LVDS 24-bit LCD RGB MIPI […]

November 28, 2014 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

Intrinsyc Introduces Snapdragon 810 Powered Mobile and Tablet MDPs, DragonBoard Development Kit

Intrinsyc has recently announced availability for three development platforms based on Qualcomm Snapdragon 810 ARM Cortex A53/A57 processor, namely a smartphone Mobile Development Platform (MDP), a tablet MDP, and a DragonBoard development kit integration Open-Q 8094 system-on-module, making these one of the first ARM64 development platforms available to individual developers, or at least small software development companies (approved by Qualcomm). All three platforms will run Android 5.0 Lollipop. Intrinsyc Snapdragon 810 MDP Smartphone Intrinsyc MDP/S specifications: SoC – Qualcomm Snapdragon 810 (8994) 64-bit octa-core processor with 4x Cortex A57 cores, 4x Cortex A53 cores, Adreno 430 GPU, and Hexagon V56 DSP System Memory – 3 GB LP-DDR4 Storage – 32 GB eMMC 5.0 micro SD slot (under battery door) Display – 6.17” QHD (2560×1600) 490ppi, 10-finger multi-touch capacitive touchscreen Video Output – micro HDMI type D Audio Headset jack with ANC support 8 microphones (2 analog/ 6 digital) with support […]