som News - Page 21 of 78 - CNX Software

June 21, 2022June 21, 2022 by Jean-Luc Aufranc (CNXSoft) - No Comments

Vecow unveils MediaTek Genio 350, Genio 500, and Genio 1200 system-on-modules and development kits

Vecow has announced a series of new system-on-modules and development kits based on Mediatek Genio 350, Genio 500, or Genio 1200 processors for AIoT applications ranging from smart security, smart retail, and traffic vision to digital signage. This follows last week’s news about ADLINK LEC-MTK-I12000 SMARC module and devkit powered by MediaTek Genio 1200 Cortex-A78/A55 AIoT processor, but Vecow also offers solutions based on the entry-level Genio 350 quad-core Cortex-A53 processor, and the mid-range Genio 500 octa-core Cortex-A73/A53 processor. ESOM-MT-350 Genio 350 system-on-module and devkit Specifications: SoC – MediaTek Genio 350 quad-core Cortex-A53 processor @ 2.0GHz with Mali-G52 GPU with support for OpenGL ES 3.2, OpenCL ES 2.0, and Vulkan 1.1, 1080p60 H.265/H.264 video decoder System Memory – 2GB LPDDR4 SDRAM Storage – 16GB eMMC flash Wireless – MT7668 WiFi 5 and Bluetooth 4.2 module with IPEX connector Audio – MediaTek MT6390/6357 audio codec Debugging – On-module debug console port […]

June 14, 2022June 15, 2022 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Raspberry Pi Compute Module 3E (CM3E) features Raspberry Pi RP3A0 SiP found in Pi Zero 2 W

After the Raspberry Pi Compute Module 4S which we discovered in April, it appears Raspberry Pi Trading has launched another Compute Module for their industrial and commercial customers with the Raspberry Pi Compute Module 3E (CM3E) equipped with the same Raspberry Pi RP30A0 SiP found in Raspberry Pi Zero 2W and an 8GB eMMC flash. The new system-on-module (SoM) has not been officially announced but was discovered by Twitter user “Pi 0 in your Pocket” inside an electric vehicle (EV) charger by Wallbox. Raspberry Pi Compute Module 3E specifications (preliminary): SiP – Raspberry Pi RP3A0 with Broadcom BCM2710A1 quad-core Cortex-A53 processor @ 1.0 GHz with VideoCore IV GPU supporting OpenGL ES 1.1, 2.0 graphics, 512MB RAM Storage – 8GB eMMC flash (other capacities might also be available TBC) 200-pin edge connector with: 48x GPIO 2x I2C, 2x SPI, 2x UART 2x SD/SDIO, 1x NAND interface (SMI) 1x HDMI 1x USB […]

June 13, 2022June 13, 2022 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

Forlinx introduces Renesas RZ/G2L system-on-module and development board

Renesas RZ/G2L or RZ/V2L Cortex-A55/M33 processors have found their way into several system-on-modules and single board computers recently with the likes of Geniatech AHAURA board, Avnet RZBoard, or ARIES Embedded MSRZG2UL OSM module among others. Forlinx Embedded has joined the fray with the Renesas RZ/G2L-based FET-G2LD-C system-on-module, and a corresponding OK-G2LD-C development board with plenty of I/Os including dual Gigabit Ethernet, RS485 and CAN Bus interfaces, built-in WiFi and Bluetooth, plus an optional EC20 4G mini PCIe module. FET-G2LD-C system-on-module Specifications: SoC – Renesas RZ/G2L (R9A07G044Lxx) dual or single-core Arm Cortex-A55 processor @1.2GHz, with real-tme Arm Cortex-M33 core @ 200MHz, Arm Mali-G31 GPU with OpenGL ES 1.1/2.0/3.1/3.2,Vulkan 1.1, OpenCL 2.0, 1080p30 VPU with H.264 AVC/MVC video encoding/decoding System Memory – 1GB / 2GB DDR4 Storage – 8GB or 16GB eMMC flash, 16MB QSPI NOR flash 3x 80-pin B2B connectors with MIPI-DSI and RGB interfaces up to 1920×1080, 2x 1000Mbps Ethernet […]

June 8, 2022 by Jean-Luc Aufranc (CNXSoft) - 1 Comment

MYIR MYC-J1028X CPU module features NXP LS1028A dual Cortex-A72 SoC with time-sensitive networking (TSN)

MYIR has introduced the MYC-J1028X CPU module based on NXP LS1028A dual Cortex-A72 processor with time-sensitive networking (TSN) support, as well as the MYD-J1028X development board with five Gigabit Ethernet ports, and other interfaces to evaluate the solution. The MYC-J1028X is equipped with 2GB DDR4, 8GB eMMC flash, a 32Kbit EEPROM, and a temperature sensor by default, and exposes all I/Os through a 314-pin MXM 3.0 edge connector. The module also comes with footprints to solder a QSPI NAND Flash, XSPI NOR Flash, and/or ECC memory. Typical applications include industrial routers, industrial control, edge computing, automotive electronics, industrial IoT, and more. MYC-J1028X CPU module MYC-J1028X SoM specifications: SoC – NXP Layerscape LS1028A (LS1028AXN7PQA) dual-core Cortex-A72 processor @ 1.5 GHz with 3D GPU, integrated TSN Ethernet switches and Ethernet controllers System Memory – 2GB DDR4 (optional 3GB / 4GB DDR4); optional DDR4 ECC Storage 8GB eMMC flash (optional 16GB / 32GB) […]

June 7, 2022June 7, 2022 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

OSM Size-0 solder-on LGA module comes with ESP32 WiFi & BLE MCU

German embedded systems company iesy’s ESP32 OSM-0F is an ESP32-based solder-on LGA system-on-module that complies with SGET OSM Size-0 (30x15mm) form factor, offers WiFi and Bluetooth connectivity, and more. The SGET Open Standard Module (OSM) standard defines four module sizes, namely Size-0 (30x15mm), Size-S (30x30mm), Size-M (45x30mm), and Size-L (45x45mm), and all the modules we’ve covered so far were powered by a Linux-capable processor. But it’s more challenging, albeit not impossible, to design a Linux-capable OSM Size-0 module, and that form factor is better suited to microcontroller-class chips like ESP32. (Technically, ESP32 can run Linux, but it’s more for show that any practical applications) ESP32 OSM-0F specifications: Microcontroller – Espressif ESP32 dual-core Xtensa LX6 MCU @ 240 MHz with 512KB RAM, Wi-Fi 802.11 b/g/n and Bluetooth/BLE Storage – 32 Mbit SPI flash Antenna – u.FL connector 188 LGA contact points with Storage – SDIO Networking – 1x 10/100M Ethernet (RMII), […]

June 6, 2022June 6, 2022 by Jean-Luc Aufranc (CNXSoft) - 12 Comments

X1501 Pico SoM – MIPS, Linux in a 16x16mm module

We’ve just written about the Notkia phone repurposing Nokia 168x phones with a new PCB featuring an Ingenic X1000E MIPS processor running mainline Linux, but it turns out the developer (Reimu NotMoe, CTO of SudoMaker) has also designed the X1501 Pico SoM, a tiny 16×16 system-on-module equipped with Ingenic X1501 MIPS system-in-package (SiP). The module can be that small because the single-core 1GHz Ingenic 1501 SiP embeds 8MB LPDDR, as well as apparently a 16Mbit NOR flash that stores stripped-down versions of U-boot and the Linux kernel, plus a minimal, busybox-based rootfs. X1501 Pico system-on-module specifications: SoC – Ingenic X1501 MIPS32r2 processor @ 1GHz, a MIPSr2 real-time core @ 300 MHz (not shown in datasheet), 8MB LPDDR and 16KB tightly coupled SRAM, 16Mbit NOR flash Castellated holes with USB 2.0 OTG, I2C, SPI, SDIO and DVP, analog mono audio output & digital microphone input EFUSE based Secure Boot Power Management […]

May 31, 2022 by Jean-Luc Aufranc (CNXSoft) - 5 Comments

ARIES Embedded unveils OSM modules based on Renesas Arm or RISC-V microprocessor

In another case of “Arm or RISC-V? Why not both“, ARIES Embedded has introduced “MSRZG2UL” and “MSRZFive” OSM compliant system-in-packages (SIPs) based on respectively Renesas RZ/G2UL Arm Cortex-A55/Cortex-M33 and RZ/Five AX45MP RISC-V microprocessors and designed for industrial controllers, IoT devices, and embedded systems with a basic GUI. Both solder-on modules come in the OSM Size S form factor (30x30mm), 512MB to 4GB of DDR4 RAM, a 4GB eMMC NAND flash, various interfaces including Gigabit Ethernet and CAN-FD, and are available in either commercial (-0°C to +70°C) or industrial (-40°C to +85°C) temperature ranges. “MSRZG2UL” and “MSRZFive” specifications: SoC MSRZG2UL module – Renesas RZ/G2UL single-core Cortex-A55 processor @ up to 1GHz with Cortex-M33 real-time core @ up to 200MHz MSRZFive module – Renesas RZ/Five single-core RISC-V AX45MP processor @ to 1.0 GHz System Memory – 512MB – 4GB DDR4 RAM Storage – 4GB eMMC NAND Flash 332 contacts with Display I/F […]

May 26, 2022December 14, 2022 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Rockchip RK3588 CPU module exposes more I/Os through four board-to-board connectors

We’ve already seen several Rockchip RK3588 modules with Firefly Core-3588J, Turing RK1, and Banana Pi RK3588_CV1, all with an edge connector to insertion into the carrier board. Rongpin RD-RK3588 system-on-module is a little different with four board-to-board connectors that enable a slightly more compact design, and should expose more I/Os than say a 314-pin MXM edge connector. The module ships with up to 16GB of RAM, 128 GB of storage, a Rockchip RK806-1 PMIC, and the company also offers a development kit with RD-RK3588-B baseboard fitted with the module for evaluation and early software development. RD-RK3588 board-to-board module RD-RK3588-C core module specifications: SoC – Rockchip RK3588 octa-core processor with 4x Arm Cortex-A76 cores @ up to 2.4 GHz, 4x Arm Cortex-A55 cores, Arm Mali-G610 MP4 GPU with support for OpenGL ES3.2, OpenCL 2.2, Vulkan1.1, 6 TOPS NPU, 48MP ISP, 8Kp60 video decoding, 8Kp30 video encoding System Memory – 4GB, 8GB, […]