3G News - Page 2 of 8 - CNX Software

November 9, 2018November 11, 2018 by Jean-Luc Aufranc (CNXSoft) - 76 Comments

Giveaway Week – ThaiEasyElec 3G Raspberry Pi HAT

3G-GPS-Tracker-Raspberry-Pi-Board-Configuration

You’ll need a 40-pin Raspberry Pi board for this giveaway. Quectel UC20 based ThaiEasyElec 3G Raspberry Pi HAT adds 3G / 2G connectivity to the popular development board. I”l send the board with the full kit include GPS/GLONASS antenna, cellular antenna, headers and spacers. I explained how to use the board in “How to Use 3G and GPS on Raspberry Pi” post, and I found that it was pretty easy working with GPS and 3G using Hologram SIM card by following the instructions provided by ThaiEasyElec. I could also find alternative connection method for this type of board on the Internet. To enter the draw simply leave a comment below. Other rules are as follows: Only one entry per contest. I will filter out entries with the same IP and/or email address. Contests are open for 48 hours starting at 10am (Bangkok time) every day. Comments will be closed after […]

July 16, 2018July 16, 2018 by Jean-Luc Aufranc (CNXSoft) - 6 Comments

Orange Pi 3G/4G Cellular IoT Development Kits with Touchscreen Display Launched for $35 and Up

Earlier this year, Shenzhen Xunlong introduced two new Orange Pi cellular IoT boards running Android – but no Linux distribution just yet – with Orange Pi 3G-IoT and Orange Pi 4G-IoT boards, with LTE bands suitable for Asia and most part of Europe, but not the US. But boards are quite cheap, the 4G-IoT model recently got Android 8.1 Oreo support, if you’d like a display with the board, you can now buy various kits with touchscreen display and in some sets a power supply as well for $34.80 and up plus shipping, or the displays only for $14.80 and up. Four kits have been launched so far: $34.80 Orange Pi 3G-IoT-A Set1 with Orange Pi 3G-IOT-A board powered by Mediatek MT6572 dual core Cortex A7 processor + 256MB RAM/512MB eMMC combo chip, and a 4.98″ TFT LCD touchscreen display (854 x 480) $39.80 Orange Pi 3G-IoT-B Set1 with Orange […]

July 12, 2018 by Jean-Luc Aufranc (CNXSoft) - 17 Comments

LEORY 3G USB Dongle Sells for Just $9.99

When Orange Pi 3G-IoT SBC was launched, I looked at 3G USB dongles to make a comparison with a similar setup based on a Raspberry Pi Zero W board and an inexpensive 3G USB stick, and the cheapest I could find was a refurbished HUAWEI E3533 model now selling for around $16 shipped. But I’ve just found one fairly cheaper with LEORY 3G USB dongle offered for only $9.99 including shipping on Banggood. Specifications listed on Banggood: Cellular Connectivity 3G UMTS/ HSDPA + 2G GSM/EDGE Frequency bands 2G – 850/900/1800/1900MHz 3G – 2100 MHz (Band 1) Transfer rate -7.2Mbps downlink SIM card slot Storage – micro SD card storage up to 16GB USB – 1x USB 2.0 port Dimensions – 9 x 3 x 1 cm Temperature Range – Operating: -20°C ~ +55°C; storage: -30°C ~ +65°C Relative Humidity – Up to 93% The dongle is said to be supported […]

June 23, 2018June 23, 2018 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

Tail it is a Family of WiFi & Cellular GPS Trackers for Things, Pets, and Bicycles (Crowdfunding)

We’ve previously written about Ping, a tiny Cellular GPS tracker that promised to last 3 months on a charge. The raising money part of the crowdfunding campaign itself was successfully with over one million dollars raised, but as with many such campaigns there have been delays, and some people still have to receive theirs, not to mention people complaining about poor battery life and other issues. But there seems to be another option now with Tail It Technologies now offering four different “Tail it” cellular GPS trackers (with WiFi too) for things, pets, and even one designed specifically for bicycles. The company has already sold their devices to thousands of customers in Norway, so they should be working, and on-time delivery should hopefully not be an issue. All four GPS trackers come with 2G, 3G, 4G, and WiFi connectivity, a 5-meter accuracy, and share the same electronics and firmware. Here’s […]

May 29, 2018 by Jean-Luc Aufranc (CNXSoft) - 24 Comments

Orange Pi 3G-IoT SBC Launched for $24.90

We had two Arm Linux SBCs with cellular connectivity from Shenzhen Xunlong so far: Orange Pi 2G-IoT for 2G connectivity, and Orange Pi 4G-IoT with LTE support in Asia and Europe. But what if you needed 3G connectivity, and did not want to spend $45 on the 4G board? There was no option until today, but the company has just launched Orange Pi 3G-IoT with WCDMA (UMTS), TD-CDMA and CDMA2000 support. Orange Pi 3G-IoT-B board specifications: SoC – MediaTek MT6572 dual core Cortex A7 processor @ up to 1.2 GHz with Arm Mali-400 GPU System Memory – 512MB DDR2 Storage – 4GB eMMC flash, micro SD slot Display I/F – FPC connector for FWVGA display (854×480) Camera I/F – MIPI connector Audio – 3.5mm audio jack, built-in microphone, 2x solder pads for optional speakers Connectivity Cellular Nano SIM card slot 2G GSM – 850/900/1800/1900 MHz 3G WCDMA -(B1/B2/B5/B8), TD-CDMA, CDMA2000 […]

April 18, 2018July 24, 2019 by Jean-Luc Aufranc (CNXSoft) - No Comments

hIoTron Modular & Enterprise IoT Development Kit is Designed for Fast Prototyping

hIoTron modular & enterprise IoT development kit is described by the company has a “fully pre-programmed prototyping kit for quickly building and testing your IoT concept” with plug-n-play module allowing for flexible prototyping. Beside the hardware comprises of a gateway and nodes, the kit also integrates with the company’s enterprise IoT Platform enabling easy design of custom mobile application & GUI dashboard. The company offers standard, advanced, and custom kits, but to keep things simple, let’s focus on the content of their standard kit first: Hi-Gate IoT gateway: WiSoC – Texas Instruments CC3200 Arm Cortex-M4 @ 80 MHz with 1MB flash, 256KB RAM Storage – 1MB serial flash, 512KB EEPROM Connectivity 802.11 n/g/n Wi-Fi, 2G GSM/GPRS (optional 3G/4G), ZigBee, BLE 4.0, sub-1GHz RF/NON RF to REST/MQTT gateway Expansion – 2x GPIO port pins, 2x analog port pins Power Supply – 9-12V DC 3x modular Hi-Nodes (up to 25 supported per […]

March 27, 2018March 27, 2018 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

1NCE to Offer a 10 Euros Plan for 10-Year of Cellular IoT Connectivity in Europe

For the Internet of Things to be successful, prices need to come down sharply, and eventually LPWAN connectivity should be possible with $1 to $2 modules, $5 to $10 development boards like we can get for WiFi today. Cellular IoT hardware is likely to be a bit more expensive – even when using NB-IoT – but hardware prices have to come down to acceptable levels, and so is connectivity. 1NCE brings us in the right direction for the latter with a SIM card selling for 10 Euros offering 10-year of 2G/3G/NB-IoT connectivity (1 Euro per year) with 500MB data included. That’s about 140KB of data per day, which should be OK for applications like smart meters. There are no other fees, except if your device goes over the limit, but the company has not provided any pricing details for the extra data. The service will cover 30 countries in Europe. […]

March 26, 2018October 21, 2021 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

A List of Cellular IoT Development Boards

We’re starting to have a decent choice of cellular development boards, and as the number of products is getting larger having some sort of list would be useful. That’s exactly what Hologram has done. While the list is not quite exhaustive, they’ve pushed the CSV list to Github, and plans to update it. Hologram also encourages pull requests, so manufacturers may consider updating it with their own boards. The list focuses on development boards acting as cellular IoT endpoints, so you won’t find gateways, WiFi hotspots, end-user devices, and modules that needs to be soldered onto your own board. I have imported the list to WordPress to make it searchable, let people select the number of rows to display, and customize visible fields. The table is not automatically synchronized, so for the latest version always check out Github. Jean-Luc Aufranc (CNXSoft)Jean-Luc started CNX Software in 2010 as a part-time endeavor, […]