Operating Systems Category - Page 121 of 1021 - CNX Software

May 15, 2023May 15, 2023 by Jean-Luc Aufranc (CNXSoft) - 3 Comments

Seeed Studio launches Jetson-based “reComputer Industrial” fanless Edge AI computers

reComputer Industral fanless Jetson Orin computer

We covered the actively-cooled reComputer J4012 Edge AI mini PC powered by Jetson Orin NX system-on-module last January, but Seeed Studio has now launched four fanless “reComputer Industrial” variants with an aluminum case, two Gigabit Ethernet ports, three USB 3.2 ports, an RS232/RS422/RS485 serial port, and a terminal block with four DI, four DO, and a CAN Bus. The four different models simply use a different Jetson Xavier NX/Orin NX/Orin Nano module: reComputer Industrial J2011 – NVIDIA Jetson Xavier NX 8GB with a 6-core NVIDIA Carmel Armv8.2 64-bit CPU, 384-core NVIDIA Volta GPU with 48 Tensor Cores delivering up to 21 TOPS of AI performance, 8GB LPDDR4x, 16 GB eMMC flash reComputer Industrial J3011 – NVIDIA Jetson Orin Nano NX 8GB with a 6-core Arm Cortex-A78AE Armv8.2 64-bit CPU, 1024-core NVIDIA Ampere GPU with 32 Tensor Cores delivering up to 40 TOPS of AI performance, 8GB LPDDR5 reComputer Industrial J4011 […]

May 14, 2023June 30, 2023 by Jean-Luc Aufranc (CNXSoft) - 10 Comments

GL.iNet Spitz AX review – Part 2: a router with 5G NR, WiFi 6, 2.5GbE, failover and load balancing

Gl.iNet Spitz AX review 5G failover testing

Earlier this month I introduced the GL.iNet Spitz AX (aka GL-X3000NR) router with 2.5GbE, WiFi 6, and 5G NR cellular connectivity listing the specifications, doing an unboxing, and going through the initial setup. I’ve now received a new SIM card for testing and installed it into the router to continue the review. 4G/5G cellular connectivity on Spitz AX router After powering the router, the SIM card was detected and showed a 5G connection, but quickly fell back to 4G as can be seen with the cyan icon in the screenshot below. Shortly after, I lost 4G data connectivity, and after a while, the modem was not detected at all. But after restarting the router, and clicking on the “Auto Setup” icon everything looked to be working fine and I was always on a 5G connection from “house 1”. You’ll notice an envelop icon on the top right corner of the […]

May 13, 2023 by Jean-Luc Aufranc (CNXSoft) - 10 Comments

UDOO VISION SBC with Intel Atom x5-E3940 or x7-E3950 CPU offers Arduino Leonardo compatibility

UDOO VISION single board computer is powered by either an Intel Atom x5-E3940 or x7-E3950 Apollo Lake processor and features the same Microchip ATmega32U4 8-bit AVR microcontroller found in the Arduino Leonardo board to control GPIOs. Two versions of the Pico-ITX SBC are available: the X5 with an Atom x5 processor, 4GB RAM, 32GB eMMC flash, and the X7 with an Atom x7 processor, 8GB RAM, and 64GB eMMC flash. Both come with miniDP++ and eDP vision interfaces, two Gigabit Ethernet ports, USB ports, M.2 sockets for expansion, and a 26-pin header with the same signals as in the Arduino Leonardo board. UDOO VISION specifications: SoC UDOO VISION X5 – Intel Atom x5-E3940 quad-core Apollo Lake processor @ 1.6 / 1.8 GHz (Turbo) with 12EU Intel HD Graphics 500 series; 9.5W TDP UDOO VISION X7 – Intel Atom x7-E3950 quad-core Apollo Lake processor @ 1.6 / 2.0 GHz (Turbo) with […]

May 12, 2023September 23, 2023 by Jean-Luc Aufranc (CNXSoft) - No Comments

EDATEC ED-IPC2010 – A compact DIN Rail mountable industrial computer based on Raspberry Pi CM4

DIN Rail Raspberry Pi CM4 industrial computer

EDATEC has launched yet another Raspberry Pi CM4-powered industrial computer with the ED-IPC2010 offering a more compact design than the company’s CM4 Industrial and CM4 Sensing models, and an aluminum alloy enclosure that can easily be mounted to a DIN Rail. Most of the specifications of the new ED-IPC2010 are pretty common with a choice of Raspberry Pi Compute Modules 4 with up to 8GB RAM, 32GB flash, and optional WiFi 5 and Bluetooth 5.0, as well as a full-size HDMI video output, a Gigabit Ethernet port, and a few USB ports. What’s a little different is one FPC connector on the mainboard with both HDMI and USB for touchscreen displays. ED-IPC2010 specifications: SoM – Raspberry Pi CM4 SoC – Broadcom BCM2711 quad-core Cortex-A72 processor @ 1.5GHz with VideoCore VI GPU System Memory – 1GB, 2GB, 4GB, or 8GB RAM Storage – 8GB, 16GB, or 32GB eMMC flash Wireless – […]

May 12, 2023May 12, 2023 by Jean-Luc Aufranc (CNXSoft) - No Comments

AMD Versal AI Edge SoC FPGA system-on-module targets ADAS, robotics, medical imaging, and other AI applications

AMD Xilinx Versal AI Edge System-on-Module

iWave Systems iW-Rainbow-G57M is a system-on-module (SoM) based on the AMD (Xilinx) Versal AI Edge series of Cortex-A72/R5 SoC FPGAs designed to deliver AI acceleration at relatively low power for demanding applications such as ADAS, robotics, and medical imaging. The module comes with up to 8GB 64-bit LPDDR4, 16GB eMMC Flash, 256MB QSPI Flash, delivers up to 45 TOPS of AI performance, and features eight transceivers that can be used for high-speed Ethernet, PCIe, MIPI DSI/CSI interfaces, and/or others as required by the customer’s specific project. iW-Rainbow-G57M specifications: FPGA SoC – AMD Xilinx Versal AI Edge/Prime SFVA784 package (VE2302, VE2202, VE2102, or VE2002) with Dual Arm Cortex-A72 core processor @ up to 1.6 GHz Dual-core Arm Cortex-R5F Up to 328K Logic cells & 150K LUTs Programmable Network on Chip (NoC) Up to 45 TOPS (INT4) AI compute 8x GTYP Transceivers @ 28.21 Gbps (VE2302 & VE2202 only) Memory – Up […]

May 11, 2023 by Jean-Luc Aufranc (CNXSoft) - 6 Comments

$14+ Allwinner T113-S3 CPU module comes with 128MB RAM, 256MB NAND flash or 4GB eMMC flash

MYiR MYC-YT113X is a low-cost solderable CPU module powered by an Allwinner T113-S3 dual-core Cortex-A7 processor with 128MB on-chip DDR3 RAM, and fitted with either a 256MB NAND flash or a 4GB eMMC flash for storage. The industrial temperature grade module provides a lower-end alternative to the company’s earlier MYC-YT507H Allwinner T507-H Cortex-A53 CPU module, and offers various display, camera, audio, Ethernet, USB, and low-speed I/Os through a 140-pin stamp hole design. It is designed for HMI, industrial automation, as well as display and control terminals. MYiR MYC-YT113X specifications: SoC – Allwinner T113-S3 CPU – Dual-core Arm Cortex-A7 @ 1.2 GHz with 32 KB L1 I-cache + 32 KB L1 D-cache per core, and 256 KB L2 cache DSP – Single-core HiFi4 VPU – H.265/H.264 video decoding up to 1080p60 and JPEG/MJPEG video encoding up to 1080p60 Memory – 128 MB DDR3 Storage – 4GB eMMC or 256MB NAND flash, […]

May 10, 2023May 19, 2023 by Jean-Luc Aufranc (CNXSoft) - 36 Comments

Orange Pi 5 Plus SBC switches to Rockchip RK3588 SoC, brings dual HDMI 2.1, dual 2.5GbE, M.2 PCIe sockets

Orange Pi 5 Plus is the first Rockchip RK3588 SBC from the company and succeeds the cheaper Rockchip RK3588S-based Orange Pi 5 and Orange Pi 5B single board computers that had a more limited number of high-end interfaces. Switching to the I/O rich RK3588 processor allowed Orange Pi to add two 2.5GbE networking interfaces, support for NVMe SSD storage up to 2,000 MB/s, up to four display interfaces with two HDMI 2.1 ports, MIPI DSI and USB-C with DisplayPort Alt. mode, as well as an extra M.2 socket for optional WiFi 6 and Bluetooth connectivity. Orange Pi 5 Plus specifications: SoC – Rockchip RK3588 CPU – Octa-core processor with 4x Cortex-A76 cores @ up to 2.4 GHz, 4x Cortex-A55 cores @ up to 1.8 GHz Arm Mali-G610 MP4 GPU with support for OpenGL ES1.1/2.0/3.2, OpenCL 2.2, and Vulkan 1.2 6 TOPS AI accelerator with support for INT4/INT8/INT16/FP16 mixed operation VPU […]

May 10, 2023May 9, 2023 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

Rongpin DR4-S905/DR4-A311D SoM features Amlogic S905D3 or A311D processor

DR4-A311D Amlogic A311D system-on-module

Shenzhen Rongpin Electronic Technology (Rongpin) DR4-S905 and DR4-A311D are SO-DIMM system-on-modules (SoM) respectively powered by Amlogic S905D3 quad-core Cortex-A55 processor and Amlogic A311D octa-core Cortex-A73/A53 processor. The modules come with 2GB LPDDR4 and 16GB eMMC flash by default, but can be ordered with up to 4GB RAM and 128GB storage, and the company offered a feature-rich carrier board to test all interfaces provided but the system-on-modules. DR4-S905 system-on-module specifications: SoC – Amlogic S905D3 quad-core Cortex-A55 processor @ 1.9GHz with Arm Mali-G31MP2 GPU up to 800MHz supporting OpenGL ES 3.2, Vulkan 1.0 and OpenCL 2.0, real-time Cortex-M4 core for always-on processing, and 1.2 TOPS NPU System Memory – 2GB LPDDR4 by default (1GB/4GB options) Storage – 16GB eMMC 5.1 flash by default (8GB, 32GB, 64GB, 128GB options) SO-DIMM edge connector for connection to a carrier board Power management – Discrete design Dimensions – 69.6 x 30mm Temperature Range – -25℃ to […]