OpenWrt Category - Page 17 of 40 - CNX Software

June 14, 2021June 14, 2021 by Jean-Luc Aufranc (CNXSoft) - 13 Comments

HaneSOM is a 4 cm2 Arm Linux module powered by Microchip SAMA5D2 SiP

DAB Embedded HaneSOM is a tiny (4 cm2) system-on-module based on Microchip SAMA5D2 Arm Cortex-A5 processor running Linux, which could make it the world’s smallest Linux module. The small size is made possible by the use of a SAMA5D2 system-in-package that also integrates 128MB DDR2, and the only two other chips on the modules are a 4MB flash (GD25Q32) and the PMIC (MIC2800). HaneSOM specifications: SiP – Microchip ATSAMA5D27C-D1G system-in-package with SAMA5D27 Arm Cortex-A5 processor @ 500 MHz with NEON, 128MBytes DDR2 System Memory – 128MBytes DDR2 memory Storage – 4 MBytes of QSPI Flash Castellated holes giving access to signal for: Storage – SD card interface Display – 24-bit RGB LCD TFT interface; capacitive touch controller Camera – Up to 5MP CMOS camera sensor support Audio – SSC, I2S Networking – 10/100M Ethernet USB – USB 2.0 (OTG and host) SPI, I2C, UART, CAN-FD, 12-bit ADC, PWM Misc – […]

June 10, 2021 by Jean-Luc Aufranc (CNXSoft) - 17 Comments

ClearFog CN9130 networking boards deliver 10GbE through a tiny Octeon TX2 module

SolidRun has designed and manufactured ClearFog networking boards ever since the introduction of the Marvell ARMADA 380/388-based ClearFog Pro in 2015. Since then, more powerful models have been launched including the ClearFog GT 8K based on Marvell ARMADA A8040 quad-core Cortex A72 processor with support for 2.5GbE and 10GbE, and the ClearFog CX LX2K equipped with a 16-core Cortex-A72 NXP capable of 100GbE networking. The Israeli company unveiled its first Octeon TX2-based design last fall with ClearFog CX CN9K, a full-featured networking SBC fitted with CEx7 CN9132 COM Express Type 7 module. But now the company has launched the more compact ClearFog CN9130 Pro/Base networking boards equipped with a tiny 50x30mm Octeon TX2 module still enabling 10GbE connectivity. SolidRun SOM 9130 system-on-module Specifications: SoC – Marvell OCTEON TX2 CN9130 quad-core Cortex A72 processor @ up to 2.2 GHz (commercial) or 2.0 GHz (industrial) System Memory – Up to 8GB DDR4 […]

May 20, 2021May 21, 2021 by Jean-Luc Aufranc (CNXSoft) - 49 Comments

Nezha RISC-V Linux SBC launched for $99 and up

Last month, we wrote about Allwinner D1 SBC & processor that promised to offer a relatively low-cost RISC-V Linux solution. We were not given a name at the time, but there was a logo of Nezha, a fictional character from Chinese literature. The board is now known as the Nezha SBC and has been launched on Indiegogo for $99 and up as a board designed for IoT projects running Linux, but can also be purchased directly on Aliexpress for the same price. [Update: It can also be purchased on Taobao for 599 RMB] Nezha SBC specifications: SoC – Allwinner D1 single-core XuanTie C906 64-bit RISC-V processor @ 1.0 GHz with HiFi4 DSP, G2D 2D graphics accelerators Memory – 1GB DDR3 memory Storage – 256MB SPI NAND flash, MicroSD card slot Video Output – HDMI 1.4 port up to 4Kp30, MIPI DSI & touch panel interface up to 1080p60 Decoding – […]

May 2, 2021May 10, 2021 by Jean-Luc Aufranc (CNXSoft) - 19 Comments

Allwinner D1 RISC-V processor SDK & Documentation

We published information about Allwinner D1 SBC and processor a few weeks ago. The news was pretty interesting as it’s the first RISC-V processor from the company, and one of the first affordable RISC-V SBC. But all we had at the time was hardware information from a leak, or rather from China-only Allwinner developer website. But now the company has added more information to its open-source development website with the release of documentation, now only in Chinese, as well as the Allwinner D1 Tina SDK. Eventually, there should be a better SDK via linux-sunxi community and some are already working on the Allwinner D1 SBC, but let’s try to get the SDK from Allwinner and build the code from source using the documentation. First, you’d need to register on Allwinner open-source website and click on signup. You’ll probably want to select Email registration. Now fill your username, select a country, […]

May 1, 2021 by Jean-Luc Aufranc (CNXSoft) - 8 Comments

DR8072A embedded router board offers dual 2.5 GbE, WiFi 6 connectivity

We’ve previously found Qualcomm IPQ8072A quad-core Cortex-A53 networking processor in WPQ873 embedded SBC with support for WiFI 6, three GbE ports, one 2.5GbE port, and support for 5G M.2 modems. The design was adapted from Qualcomm HK09 reference design, and now another company, Wallys Communications, has launched another board based on HK09. DR8072A embedded router board is somewhat similar to WPQ873, but does come with two 2.5GbE ports instead of just one, one extra Gigabit Ethernet port, among other smaller changes. DR8072A specifications: SoC – Qualcomm Atheros IPQ8072A quad-core ARM 64 bit A53 @ 2.2GHz part of Qualcomm Networking Pro 600 Platform System Memory – 1x 512MB, DDR4 2,400 MHz 16-bit interface Storage – 256MB NAND flash, 8MB NOR flash Networking and Wireless Connectivity Ethernet 4x Gigabit Ethernet RJ45 ports 2x 2.5 Gbps Ethernet RJ45 ports WiFi On-board 4×4 2.4GHz MU-MIMO OFDMA 802.11b/g/n/ax, up to 1182 Mbps, max 17dBm per […]

April 21, 2021April 27, 2021 by Jean-Luc Aufranc (CNXSoft) - 14 Comments

Business card-sized dual GbE SBC runs OpenWrt on Rockchip RK3328 SoC

We’ve previously reported about at least two dual GbE router boards based on Rockchip RK3328 quad-core Cortex-A53 processor with namely NanoPi R2S and Orange Pi R1 Plus. But there’s now a third option with SmartHomeBoard Pi-R2S3328-B single board computer offered in a larger business card-sized format, equipped with 1GB DDR4, and booting OpenWrt from a MicroSD card. Debian and Ubuntu are also supported according to the manufacturer. Specifications: SoC – Rockchip RK3328 quad-core Cortex-A53 @ 1.5 GHz with Arm Mali-450MP2 System Memory – 1GB DDR4 RAM (Note some photos how 2x 512MB DDR3 instead) Storage – MicroSD Slot Connectivity -2x Gigabit Ethernet RJ45 ports, one native, one USB 3.0 to GbE USB – 1x USB Type-A host port, 1x micro USB OTG port, 1x USB Type-C port for power Debugging – 3-pin 2.54mm pitch header for serial console Misc – Reset button, Sys,WAN and LAN LED’s, Power Supply – 5V/2A […]

April 14, 2021 by Jean-Luc Aufranc (CNXSoft) - No Comments

Check LoRaWAN deployments on the go with WisGate Developer Base USB dongle

RAKWireless just had their “Big Tech Bloom” event services they announced many new LPWAN products ranging from WisDM fleet management system, OpenWrt based Wisgate OS, new industrial LoRaWAN gateways like WisGate Edge Lite 2, their first STM32WL module, as well as 9 new modules for WisBlock modular IoT platform with MIC, e-Paper display, GPS, an ESP32 based WisBlock core, etc… But today, I’ll have a look at the new $99 WisGate Developer Base, a USB dongle that connects to a laptop for LoRaWAN networks evaluation, for example, to check the coverage before installing a new gateway. Alternatively, it could also be used to add LoRaWAN gateway capability to existing embedded hardware like routers or industrial PCs. Two variants of the WisGate Developer Base are available – RAK7271 & RAK7371 – with the following specifications: Concentrator modules RAK7271 – RAK2287 SX1302 based mini PCIe concentrator module RAK7371 – RAK5146 SX1303 based […]

April 6, 2021April 7, 2021 by Jean-Luc Aufranc (CNXSoft) - 9 Comments

Xiaomi Mi AX9000 WiFi 6 Enhanced router supports up to 1000 clients

Xiaomi launched the Mi AX6000 WiFI 6 Enhanced router, not to be confused with WiFI 6E, at the beginning of the year. The router offers up to 4804Mbps link at 5 GHz, and up to 574Mbps with a 6+1 antenna configuration, as well as one 2.5GbE port, and several Gigabit Ethernet ports. But for people requiring even more bandwidth, Xiaomi Mi AX9000 WiFi 6 Enhanced router offers even more wireless throughput using three frequency bands with four antennas each, and up to 1148 Mbps at 2.4 GHz, up to 4804Mbps at 5.2GHz, and up to 2402Mbps at 5.8GHz, which the company refers to as the 5G_Game band. Xiaomi Mi AX9000 WiFI 6 Enhanced Edition router specifications: SoC – Qualcomm IPQ8072 quad-core Cortex-A53 processor @ 2.2 GHz with dual-core 1.7GHz NPU (network acceleration engine / processing unit) System Memory – 1GB RAM Connectivity Wired 1x 2.5GbE LAN/WAN port 1x Gigabit Ethernet […]