Hardware Category - Page 666 of 1133 - CNX Software

October 30, 2017 by Jean-Luc Aufranc (CNXSoft) - 13 Comments

NanoPi Duo Quick Start Guide – Ubuntu, Breadboard, Mini Shield & mSATA SSD

As far as I know NanoPi Duo is the only quad core ARM Linux development board that can fit on a breadboard. We’ve already seen it’s much smaller than Raspberry Pi Zero, and the company offer a mini shield exposing USB ports, Ethernet, a few I/Os, and an mSATA slot in in NanoPi Duo Starter Kit Review – Part 1: Unboxing and Assembly. I’ve finally played with it this week-end, and will report what I had to do to blink a LED when connected to breadboard, and my experience using the mini shield with an mSATA SSD, WiFi connectivity, and cooling under load. Flashing Ubuntu 16.04.2 firmware image to NanoPi Duo As with many other Allwinner development boards, you should first check if Armbian is available for the board. NanoPi Duo is not supported, but it’s said to work with Orange Pi Zero image minus support for WiFi. Since the […]

October 30, 2017November 1, 2017 by Jean-Luc Aufranc (CNXSoft) - 179 Comments

Giveaway Week – NanoPi NEO NAS Kit with NEO 2 Board

Time has come to organize another giveaway week. I used to mainly give away TV boxes, but due to recent regulations that will not be possible anymore, and instead this giveaway week will include Linux and IoT development boards, and other accessories. I’ll start with NanoPi NEO NAS Kit v1.2. NanoPi NEO NAS Kit v1.2 is a low cost kit NanoPi NEO or NEO 2 board that takes a 2.5″ hard drive. I’ve tested it with NanoPi NEO 2 board and OpenMediaVault, and found to perform optimally for this type of device (USB 2.0 to SATA), with SAMBA reads & writes achieving 40 MB/s. The hardware given away includes the NAS Kit v1.2 and a NanoPi NEO 2 board. You’ll just need to add a micro SD card with the OMV image, a hard drive, and a 12V/2A (or greater) power supply. To enter the draw simply leave a comment […]

October 29, 2017October 30, 2017 by Jean-Luc Aufranc (CNXSoft) - 12 Comments

Intel Optane 900P Series SSD Launched for Desktop PCs

Intel and Micron first unveiled 3D Xpoint technology (pronounced “crosspoint”) in 2015 with the promise of 1000x faster storage and 1000x better endurance than NAND flash used in SSDs. Performance was later reduced to about 7x better IOPS in a prototype, and Intel started to sell the technology under the Optane brand with the 375GB SSD DC P4800X for the enterprise market. Since then Intel entered the consumer market with 16GB and 32GB Optane M.2 cards which are meant to be used as disk cache in compatible systems thanks to their high random I/O performance, and now the company has announced the first consumer grade 3D Xpoint SSDs for desktops and work stations with Optane 900P Series available in HHHL (CEM3.0) and U.2 15mm form factors, and with random I/O performance up to four times faster than competitive NAND-based SSDs. Optane SSD 900P Series specifications: Capacity – 280 to 480 […]

October 28, 2017 by Jean-Luc Aufranc (CNXSoft) - 4 Comments

Intel Speech Enabling Developer Kit Works with Alexa Voice Service, Raspberry Pi 3 Board

We’ve known Intel has been working on Quark S1000 “Sue Creek” processor for voice recognition for several months. S1000 SoC is based on two Tensilica LX6 with HiFi3 DSP, some speech recognition accelerators, and up to 8x microphones interfaces which allows it to perform speech recognition locally. The solution can also be hooked to an application processor via SPI, I2S and USB (optional) when cloud based voice recognition is needed. Intel has recently introduced their Speech Enabling Developer Kit working with Amazon Alexa Voice Service (AVS) featuring a “dual DSP with inference engine” – which must be Quark S1000 – and an 8-mic array. The kit also includes a 40-pin cable to connect to the Raspberry Pi 3 board. Intel only provided basic specifications for the kit: Intel’s dual DSP with inference engine Intel 8-mic circular array High-performance algorithms for acoustic echo cancellation, noise reduction, beamforming and custom wake word […]

October 27, 2017October 27, 2017 by Jean-Luc Aufranc (CNXSoft) - 2 Comments

Emcraft Releases Linux BSP for NXP i.MX RT1050 Cortex M7 Evaluation Board

NXP iMX RT series is a family of ARM Cortex M7 processors clocked at 600 MHz, making the solution a “crossover embedded processor” bridging the gap between real-time capabilities of micro-controllers and the performance of application processors. This week, NXP provided some benchmark numbers for i.MX RT1050 processor, which delivers a CoreMark score of 3020, DMIPS of 1284, and 20ns interrupt latency at 600 MHz, which means it could be a good candidate for embedded Linux, and Emcraft Systems has just released a uCLinux BSP for the NXP i.MX RT1050 EVK board. The BSP features U-Boot v2017.09-rc1, Linux Kernel 4.5 with relevant device drivers such as key I/O interfaces, Wi-Fi, SD card, LCD, etc…, and GNU development tools such as a GCC 4.7 toolchain, GDB, and so on. The company has made a demo with a GUI application designed with Crank Software’s Storyboard Suite, and running in Linux on the […]

October 27, 2017October 27, 2017 by Jean-Luc Aufranc (CNXSoft) - 5 Comments

Use your Smartphone as an IR Remote Control with ROCK USB Type C IR Remote Control Transmitter

A few years ago, I wrote about ZazaRemote transforming your smartphone into a universal IR remote control. ZazaRemote is a hardware and software solution that combines infrared dongles micro USB port or 3.5mm audio plug, and a mobile app that allows you to control all sort of devices (TV, aircon, etc…) from your smartphone. Over three years later, more and more phones are now deprived from the audio jack, and micro USB ports have given way to USB type C ports, so that solution does not work anymore on newer phones. Some of the recent phones like Xiaomi Mi A1 integrate an IR transmitter, but for others, Zazaremote’s developer (Tiqiaa) has apparently not come up with a USB type C version, but just sells micro USB to USB type C adapters, not the most convenient. Upon further research, I eventually found a USB type C IR transmitter for smartphone sold […]

October 27, 2017November 8, 2017 by Jean-Luc Aufranc (CNXSoft) - 11 Comments

A95X R1 4K Android TV Box Sells for $20 (Promo)

Rockchip RK3229 quad Cortex A7 processor powers some of the cheapest TV boxes on the market. One of them is A95X R1 with 1GB RAM, 8GB flash, which likeother RK3229 boxes supports both 4K H.265 and H.264, and outputs up to 3840×2160 @ 60 Hz via its HDMI 2.0 interface. GearBest is now selling the device for $19.99 shipped using coupon AA95XR1. A95X R1 specifications: SoC – Rockchip RK3229 quad core ARM Cortex A7 processor @ 1.5 GHz with ARM Mali-400MP2 System Memory – 1GB DDR3 Storage – 8GB flash + micro SD card slot up to 32GB Video Output – HDMI 2.0 up to 4K @ 60 fps, and 3.5mm AV output (composite) Audio Output – HDMI, AV, and coaxial S/PDIF Connectivity – 100Mbps Ethernet, 802.11 b/g/n WiFi (RTL8189) USB – 2x USB 2.0 host ports Power Supply – 5V Dimensions – 9.3 x 9.3 x 1.5 cm Weight […]

October 27, 2017 by Jean-Luc Aufranc (CNXSoft) - No Comments

Sonoff Wireless Switch Family Gets a $3 IP66 Waterproof Enclosure

ESP8266 powered ITEAD Studio Sonoff wireless switches have been popular because they are inexpensive, highly customizable thanks to work from the community leading to open source projects such as ESPurna and Sonoff-Tasmota, and come fully packaged so you don’t need to make your own case for it. That works well for indoor projects, but if you needed to control outdoors lights, gate, water pump, etc… you had to protect the device from humidity/rain. That may not be necessary anymore as the company is now selling Sonoff Basic with an IP66 waterproof enclosure for $7.75, or the case only for $2.90.Sonoff waterproof case: Ingress Protection Rating – IP66 Material – PC V0 Dimensions – 132.2 x 68.7 x 50.1mm (See details) Weight – 145.0g IP66 rating is not suitable for prolonged immersion, but it should be good to protect against rain or high humidity. The box ships with two standardized PG7 […]